Model Realism - Problem with loops

[Sundance]

I seem to have a problem with all models when trying to loop or hover. Whenever I go into a loop either from level flight or after a dive to increase speed the plane flips over or snap rolls instead of going smoothly over at the top of the loop. It doesn't seem to matter whether I go into a gentle loop or a tight one. The same happens in a hover just as the model is vertical.

Anyone know what may be causing this? When I use the same controls with RCFsim the loops are very smooth.

Thanks

[ggunners]

Sundance,

I've seen this too. What I did was check the exponential box for aileron. Then when you're using the elevator to perform a loop it'll be easier to keep the stick centered. Otherwise, it can be quite difficult to do a loop without falling out of it in some way.

-- ggunners

[Sundance]

Ggunners;

Thanks for the speedy reply. I gave your suggestion a try but unfortunately it didn't make any difference.

Are there any others out there that have the same problem and if so what is the solution.

By the way I am running FMS on a Pentium 4, 2.8GHz with 512Meg and Intel mother board using the 865 chipset which has its own on board video. I am using a Hitec Optic 6 with USB interface. By the way I do not have this problem with RCFsim but I would really rather run FMS as it has a much larger selection of models available.

Thanks again.

[ggunners]

Sundance,

Alternatively, dial down your control throws on either your radio or by modifying the .par files for the models you fly.

You have to much throw right now. It's very easy to snap roll when they're set too high.

-- ggunners