I need to know if this software will run on my machine. Windows 98 SE, 125MGH Pentium®. Dont know if I have posted in the right place or not??? Any help would be greately appreciated.
Ron
NEW GUY NEEDING INFO.
2 posts
• Page 1 of 1
by ggunners » Mon Aug 02, 2004 4:00 pm
You don't say what video card you have. This is a 3D application using DirectX 9. Your 125Mhz Pentium will have a tough time keeping up. Most folks recommend a 400Mhz to 600Mhz machine with a good 3D card. 3D cards can be had for about $30 - $50 for good ones these days.
If you have a 3D card, give it a try. You may want to try the DOS version first. I think it's requirements are less but I have no 1st hand experience with it.
Another thing you might try is to reduce colors and make the models simpler by reducing the polygon count with Metasequoia. I do that on my older laptop so I can get an OK frame rate without using a 3D card.
-- ggunners
If you have a 3D card, give it a try. You may want to try the DOS version first. I think it's requirements are less but I have no 1st hand experience with it.
Another thing you might try is to reduce colors and make the models simpler by reducing the polygon count with Metasequoia. I do that on my older laptop so I can get an OK frame rate without using a 3D card.
-- ggunners
-
ggunners - Posts: 1480
- Joined: Tue Aug 26, 2003 3:47 pm
- Location: Chantilly, VA USA
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests