Hi!
Mail it to me , I will look!
landscape restrictions - ristrictions on building size?
4 posts
• Page 1 of 1
by schumi » Wed Feb 06, 2002 9:28 am
bis denne.....
(¯`·.¸Schumi¸.·´¯)
Moderator im
http://www.rc-sim.de
FMS-forum
..:::Lieber arm dran, als Bein ab:::..
(¯`·.¸Schumi¸.·´¯)
Moderator im
http://www.rc-sim.de
FMS-forum
..:::Lieber arm dran, als Bein ab:::..
-
schumi - Posts: 55
- Joined: Fri May 18, 2001 9:10 am
- Location: Ruhrgebiet
by The Gster » Tue Feb 26, 2002 4:46 pm
VeryMadmax,
I find this to. whenever the size of the .geo file for any one object is more than aprox. 50kb then it will not load in Fms, however if you put in 2 of the object at half the deatail then it loads fine. Also I think that there might be a total scenery file size but i'm not too sure. ???
I find this to. whenever the size of the .geo file for any one object is more than aprox. 50kb then it will not load in Fms, however if you put in 2 of the object at half the deatail then it loads fine. Also I think that there might be a total scenery file size but i'm not too sure. ???
Thanks The G'ster
-
The Gster - Posts: 10
- Joined: Mon Feb 25, 2002 7:06 pm
by verymadmax » Wed May 01, 2002 1:05 am
mybee that is what i will try. just split up my objects into a couple of objects.
thanks for the advise. mybee someone can tell us what the deal is.
thanks for the advise. mybee someone can tell us what the deal is.
i am not realy mad that is just my nickname
- verymadmax
- Posts: 42
- Joined: Sat Nov 03, 2001 9:57 pm
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 23 guests