In the calibrate dialog of FMS i had to CENTER the controls (after setting max/min values), but that is not possible width a power switch
Is there a know solution for that problem?
Calibrate with a power switch - Calibrate with a power switch
1 post
• Page 1 of 1
by Fred Krom » Mon Jan 19, 2004 12:26 pm
I'am using a home made atmel avr controler chip (at90s1200) with my own software and a transmiter with only 3 channels PPM (L/R, UP/DOWN, and power switch ON/OFF).
In the calibrate dialog of FMS i had to CENTER the controls (after setting max/min values), but that is not possible width a power switch
Is there a know solution for that problem?
In the calibrate dialog of FMS i had to CENTER the controls (after setting max/min values), but that is not possible width a power switch
Is there a know solution for that problem?
- Fred Krom
- Posts: 1
- Joined: Mon Jan 19, 2004 12:16 pm
1 post
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests