1 last FMS 8 par file question - wing location..

[eclipsegsxr]

OK ,
I know that surface 1 and 2 are for top left and right wing
and that surface 6 and 7 are for bottom left and right wing.

Now where do I locate a mono-wing (combat plane) at. Do I put it in surface 1 and 2 or and leave out surface 6 and 7???

Or do I put it in surface 6 and 7 and then take out surface 1 and 2??, on the other side of this one is, will fms tweak out and get the surfaces all mixed up by eliminating surface 1 and 2 or should i just keep surface 1 and 2 in and just fill it with all Zero's for everything..

any thoughts??
brad

[ggunners]

eclipsegsxr,

On the Pitts, 6 is right lower wing, note the coordinates, Y positive is to right of center.

If your plane has 2 wings, you'll have 5 surfaces, 1 - left wing, 2 - right wing, 3 - elevator, 4 - rudder, 5 - fuse.

Just delete 7 & 8.

-- ggunners