helicopter calibration

[linus3b]

Hi

I fly helicopter. I am using the four last buttons to calibrate, but I am not sure I am doing it right. I would like also to know if is it possible to disconnect the engine from the collective signal (so that I can do autorotation)

Thanks

[Eddi E. aus G.]

Don't know if you got it going already but for my Graupner/JR Tx it's fairly simple. Set your Tx to a standard plane flying mode, all mixes and trims reset, then calibrate in FMS, then maybe reverse servo channels if needed (in the sim, not on the Tx). Maybe it's easier to setup for plane flight first, then to copy the settings to the heli checkboxes.

Autos would be cool, but to my knowledge that's not possible with FMS (yet?)

__