I have one Transmitter From Esky 3D
is it CCPM control system transmitter
cannot play FMS?
how can I do?
thanks
CCPM Transmitter - Help
2 posts
• Page 1 of 1
by Olatheflyer » Thu Dec 23, 2004 5:33 pm
CHeck out this link.
You will have to check your channel settings. I had to swap the channels for my Esky Honeybee 2 transmitter. You will also have to set some of the channels to reverse, which is different than the hobbyjapan link shows. I had to reverse my Roll. The link will get you close though. If your controls are not right, expermint with the control settings. Check you channels and reverses.
The top 4 settings are for the planes. The bottom are for the helis. Set up both. If you are not sure on the bottom 4 the names are different but are in the same logical order as the top. Rudder=pitch, Elevator=Nick, etc. Also. Set the control to standard, not helicopter. The esky controls the collective with the pitch. It is not seperate like a regular heli transmitter.
If you don't you will see that the heli revs up to full throttle, but won't leave the pad/fly. Don't forget to calibrate like th link show.
Hope this helps. I just got my Honeybee 2 two days ago and this is my first heli. I can't fly yet. You do know about RADD's webpage school and the beginer's guide don't you?
Both free and found here-
RADD http://www.dream-models.com/eco/flying-index.html
Beginer Manual http://ehbg.rchomepage.com/
Get version 14, the latest manual.
You will have to check your channel settings. I had to swap the channels for my Esky Honeybee 2 transmitter. You will also have to set some of the channels to reverse, which is different than the hobbyjapan link shows. I had to reverse my Roll. The link will get you close though. If your controls are not right, expermint with the control settings. Check you channels and reverses.
The top 4 settings are for the planes. The bottom are for the helis. Set up both. If you are not sure on the bottom 4 the names are different but are in the same logical order as the top. Rudder=pitch, Elevator=Nick, etc. Also. Set the control to standard, not helicopter. The esky controls the collective with the pitch. It is not seperate like a regular heli transmitter.
If you don't you will see that the heli revs up to full throttle, but won't leave the pad/fly. Don't forget to calibrate like th link show.
Hope this helps. I just got my Honeybee 2 two days ago and this is my first heli. I can't fly yet. You do know about RADD's webpage school and the beginer's guide don't you?
Both free and found here-
RADD http://www.dream-models.com/eco/flying-index.html
Beginer Manual http://ehbg.rchomepage.com/
Get version 14, the latest manual.
- Olatheflyer
- Posts: 3
- Joined: Thu Dec 23, 2004 5:08 pm
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 84 guests