FMS + JR Interface - Interface question

[GizmoGeek]

I have the latest FMS and JR 3810 and a connection lead - however, cant seem to control Helicopter models but works fine with Airplane models

PS: already using PPM

Any suggestions please

Regards
GizmoGeek

[Rockfist Rogan]

I have said this before...a SEARCH would have found it.

Set your channels 5 -8 to the same numbers as the first 4
For instance I have mine set to:

Rudder 4
Elevator 2
(Right stick)
Aileron 1
Throttle 3
(Left stick)
(These are AIRCRAFT settings)

Tail 4
Nick 2
(Right stick)
Roll 1
Pitch 3
(Left stick)
(These are HELICOPTER settings)

Note that only the first 4 blue columns actually move up and down when calibrating. Don't worry about it!

Ticking exp (exponential) can help a LOT with helicopter flying <g>
HTH

RR

[GizmoGeek]

Thanks a lot RR.

Sorry, I did have quick loook up and down the Forum - but I'm new here don't know my way around yet.

In futher I shall SEARCH first before asking a question.

For now thanks for you help - it has solved my problem, everything works now.

Much appreciated.

Regards,
GG

[Rockfist Rogan]

I'm sorry if that sounded a bit rude, it wasn't meant to be!
I just pasted in a reply I have used several times now, and doubtless will do again...

This question comes up time and time again, and people really shouldn't have to search for the answer in the first place, IMHO.

RR