control throws - How to increase control movements

[77-1027779658]

I have a ff6 Tx with interface works O.K.

However can't do knife edges as only get very little rudder movement each way and can't turnaround on runway. How do I increase the throw as I have max atv on Tx

Mike

[Eric Brouwer]

Unfortunattely, the steering wheel is not supported in FMS. However, the other parameters can be modified in the plane's PAR file. Below, some more info on the PAR file.

Value and description

0 ModelType: 0 = Plane / 1 = Heli
1.5 Thrust in Newton
0.19 Movement/deflection of rudder in 'rad'
0.16 Movement/deflection of elevator in 'rad'
0.003 Aileronmovement/-deflection (wingtorsion) in 'rad'
1.15 'camax' of main wing
-0.3 'camin' of main wing
6.2 The way it rises, gets lift/up
2.0 'dcaue'
0.008 Value of resistance/drag of main wing
0.002 Value of resistance/drag of fuselage
0.5 'mue' underside
1.4 'mcwue'
-0.09 Stalling point main wing (moment of inertia?)
0.06 Angle of attack of main wing comp to fuselage in 'rad'
4.000 Wingspan in meters
0.21 Wingarea of main wing in (square?) meters
0.090 CG, distance from frontside main wing in meters
1.9 Weight of the model in kilograms
0.16 Moment of inertia yaw/vertical axis
0.099 Moment of inertia pitch/lateral axis
0.08 Moment of inertia .../horizontal axis
0.094 Area/surface of elevator in square meters
0.028 Area/surface of rudder in square meters
0.838 Lever tailsection in meters
0.004 V-degree of main wing
0.162 Height of model (for graphics only)

Remember to make a back-up of your old file first.

[cbattersby]

It appears that when you calibrate the interface with FMS, it negates the settings of ATV. I did the calibration with ATV at max and then use ATV settings on XMIT to reduce maximum control surface range.

Appears you have the opposite problem.



Clint