USB interface problems? - Thottle is always full

[jrhardyhd]

Hello everyone, I am a new member my name is Jeff Hardy and I am from the United States. I have been a RC pilot for 17 years and I am new to this FMS sim world. I have just purchased the Hitec USB adapter. I have a Futaba 9ZAP radio to use it with. When I first used FMS it worked fine. The second time I used it, the throttle is only seen as full. I have tried recalibrating repeatedly with no luck.
Any ideas???

Thanks,
Jeff

[Eric Brouwer]

You must ensure that the interface is calibrated correct under Control Panel/Gaming Options first, before seting up FMS. When you have calibrated it under Gaming Options, and everything looks ok, recalibrate the interface under FMS as well.

[jrhardyhd]

I am a bit upset. The throttle problem was not with the link or the transmitter, my throttle channel died. It is stuck at about 2/3 throttle. I am kind of suspicious about the cable though. Is it possible that the cable did this to my transmitter? I have never had this kind of problem with a radio before. Upon messing around with it some more. It will no longer even boot up. :angry: There goes my flying season.