Yesterday I got the PIC Interface kit from Ken. I assembled it and then certainly wanted to play. Unfortunately I couldn't calibrate the Tx. The bars didn't move in any direction and therefore the plane didn't respond to my Tx either.
What am I missing here? :confused: It seems that FMS don't get a signal, correct? How do I have to set up my Tx? The Tx is used as a student Tx and therefore doesn't need any programming or am I mistaken?
I run WinXP and COM1 is set up as described (9600 Baud, Data bits/sec: 8, Parity: None, Stop bits: 1, Flow control: none). I use a Futaba FC28 which is set on PPM mode. I tried it with the RF (module) turned on and off and obviously both didn't work.
Any help is greatly appreciated. Thanks,
Holger